This is the new NDS-22 receiver.

Ready for you to build your "Ultimate" 10/22© type rifle. It takes standard M16A1 type rear sight parts.

In addition to the iron sights, it also has a MIL-STD-1913 rail interface for optics mounting.

Perfect for building an "Appleseed" Liberty Training Rifle.

You will have to use a taller front sight such as the NDS-23 offered below.

Or the front sight base from:

www.tech-sights.com 

Be advised; you will need the extra tall A2 front sight post (available from DPMS) in the Tech-Sight base, as our rear sight is higher above the bore.

Material is 6061 T6

The anodizing is done by Victor @ US Anodizing in his "XM" gray. This is a great match for Parkerized steel, or Brownell's Alumahyde spray on finish.

NDS-22 receiver

qty 1  $160 shipped

2-5   $155 ea.

6-20 $150 ea. 

Status: temporarily out of anodized parts, next batch due in 2 weeks

The hole in the front of the receiver (above barrel) is the rear attachment point for a top handguard we are working on. It will go with the "trainer stock" I'm working on.

This is our front sight base for the NDS-22 receiver.

It's sized to work with .920" diameter barrels only.

It takes an SKS front sight post (included), and is secured with two 10-32 set screws. It is also spot-drilled on the side for those that wish to drill and pin the front sight base to their barrel.

There is a great range of elevation adjustment, so it will work with a variety of other receiver sights.

NDS-23 front sight

$30 + $5 shipping

Status: in stock/ready to ship  shipping is free if purchase/shipped with any NDS receiver

Machined from 6061 T6 billet aluminum. This receiver has a MIL-STD-1913 rail interface for optics mounting.

Standard finish is a black type 3 hardcoat anodizing.

We are also looking at doing a "clear/silver" finished model for customers with stainless steel barrels. More details later.

NDS-22R receiver

qty 1  $140 shipped

2-5   $135 ea.

6-20 $130 ea. 

Status: temporarily out of anodized parts, next batch due in 2 weeks